ISTQB CTFL-Foundation Dumps

Debugging and Testing are key activities in the software development lifecycle.
Which of the following are 'Debugging' activities?
a) Identifying, a failure
b) Locating the cause of failure
c) Fixing the defect
d) Checking the fix has resolved the failure

A new testing tool has been selected for an organisation and a pilot project has
successfully completed. The next step is to deploy the tool within the organization.
What is a key success factor in tool deployment?

A booking system for a city bus service prices its fares according to the time of travel:
• Peak-time tariff starts at 0600 and finishes at 1000 am
• Off-peak tariff applies during all other times of service
• The bus service does not operate between 2300 and the start of the next day’s peak
service
Note that all times mentioned are inclusive.
When applying the equivalence partitioning test design technique, which of the following
options, shows test case inputs that each fall into a different equivalence partition?

Which of the following would achieve the HIGHEST level of testing independence for a
project's test level?

In the above State Table, which of the following represents an invalid transition?

Which of the following would you NOT expect to see on an incident report from test
execution?

You are examining a document which gives the precise steps needed in order to execute a
test.
What is the correct definition of this document?

Which of the following does NOT represent one of the three triggers for maintenance
testing an operational system?

The decision table above shows a company's fuel expenses structure.
Which of the following Test Cases based on the decision table are Valid?
Test Case 1:
An employee who is not a car or motorcycle driver attempts to claim fuel expenses.Expected result: Expense claim not allowed.
Test Case 2:
An employee who drives a 1700cc diesel car attempts to claim fuel expenses. Expected
result: Expense claim accepted at band C.
Test Case 3:
An employee who rides a motorcycle attempts to claim fuel expenses. Expected result:
Expense claim accepted at band A.

When can functional and structural testing BOTH be applied?