3M0-211 Practice Test

Which command shows the Quality of Service (QoS) settings for Interface Module #2, Ethernet
port #6, on the Switch 7700?

A.

display qos Ethernet 6/2 all

B.

display qos Ethernet 2/0/6 all

C.

display qos-interface Ethernet 2/0/6 all

D.

display qos-interface Ethernet 6/0/2 all

How can you get the current temperature and upper/lower limits for each Switch 7700 and Switch
8800 Interface Module?

A.

Display interface

B.

Display temperature

C.

Display environment

D.

Display interface-temperature

E.

Display interface-environment

Which three Physical Layer components should you check when either the Switch 7700 or Switch
8800 is having a connection problem? (Choose three.)

A.

Link LEDs

B.

Switch ARP tables

C.

Switch VLAN assignments

D.

MAC addresses for the link

E.

RX error statistics for the link

F.

Link Speed, duplex mode and flow control

Which three may be the cause of a Switch 7700 Network Layer 3 problem? (Choose three.)

A.

The switch trunk ports are not properly configured

B.

 The RIP versions are not the same between switches

C.

 The switch is not sending and receiving route updates

D.

Spanning Tree Protocol (STP) is disabled on the switch

E.

The MAC address table "aging parameter" is set too high

F.

Virtual Router Redundancy Protocol (VRRP) is not properly configured on the switch

When two PCs on the same Virtual LAN (VLAN) are unable to communicate with each other,
which three procedures will help troubleshoot the Layer 2 Data Link issue? (Choose three.)

A.

 Flush the IP routing table

B.

Check the VLAN settings for each port

C.

Check the LED status on each of the ports

D.

Clear and reset the Spanning Tree Protocol table

E.

Flush the Address Resolution Protocol (ARP) table

F.

Check the bridge forwarding table to ensure the IP/MAC address assignment is correct