Latest 300-815 Exam Questions

A user’s phone is already configured for Single Number Reach, and the user wants a
feature to move an active call from a mobile phone to a desk phone and vice-versa. As an
administrator, which additional configuration should be made to fulfill the user’s request?

The administrator of ABC company is troubleshooting a one-way audio issue for a call that
uses H.323 protocol (slow-start mode). The administrator requests that you provide the IP
and port information of the Real- Time Transport Protocol traffic that had the one-way audio
call.
You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can
you find the RTP IP and port information for both sides? (Note: This call flow has not
invoked any media resources like MTP or transcoders).

Refer to the exhibit.

A user dials 84969010 and observes that the call is not routed immediately. The
administrator notices that after matching the fixed-length translation pattern, the call hits the \+! pattern and waits for interdigit timeout What should be configured to ensure that the call routes out immediately?

Refer to the exhibit.

An administrator is troubleshooting a situation where a call placed from a phone registered to Cisco Unified Communications Manager does not complete. The administrator wants to use the Dialed Number Analyzer on Cisco Unified CM to check which translation pattern the call is matching. However, when logging in to Cisco Unified Serviceability there is no option for Dialed Number Analyzer under the tool menu. Which two steps must be performed to resolve this issue? (Choose two.)

Which description of RTP timestamps or sequence numbers is true?

A network engineer designs a new dial plan and wants to block a certain range of numbers (8135100 through 8135105). What is the most specific route pattern that can be configured to block only the numbers in this range?

Which top-level IOS command is needed to begin the configuration of a Cisco Unified Communications Manager Express gateway to enable phones to be registered via SIP?

You see the voice register pool 1 command in your Cisco Unified Communications
Manager Express configuration. Which configuration is occurring in this section?

Refer to the exhibit

A company has users that are logged in to hunt groups. However, there is a requirement
for hunt group configurations to provide an option to turn on audible ringtones when calls to
a line group arrive at a phone that is logged out and on a break. This ringtone alerts a
logged-out user that there is an incoming call to a hunt list to which the line is a member,
but the call does not ring at the phone of that line group member because of the logged-out
status. Which action meets this requirement?