Go Back on NSE7_SDW-7.2 Exam
Available in 1, 3, 6 and 12 Months Free Updates Plans
PDF: $15 $60

Test Engine: $20 $80

PDF + Engine: $25 $99

NSE7_SDW-7.2 Practice Test


Page 2 out of 19 Pages

Refer to the exhibit.

The device exchanges routes using IBGP. Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)


A. Each BGP route is three hops away from the destination.


B. ibgp-multipath is disabled.


C. Additional-path is enabled.


D. You can run the get router info routing-table database command to display the additional paths.





C.
  Additional-path is enabled.

D.
  You can run the get router info routing-table database command to display the additional paths.

What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)


A. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.


B. It improves SD-WAN performance on the managed FortiGate devices.


C. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.


D. It acts as a policy compliance entity to review all managed FortiGate devices.


E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.





A.
  It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.

E.
  It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

Which action fortigate performs on the traffic that is subject to a per-IP traffic shaper of 10Mbps?


A. FortiGate applies traffic shaping to the original traffic direction only.


B. FortiGate shares 10 Mbps of bandwidth equally among all source IP addresses. RIAS


C. Fortigate limits each source ip address to a maximum bandwidth of 10 Mbps.


D. FortiGate guarantees a minimum of 10 Mbps of bandwidth to each source IP address.





C.
  Fortigate limits each source ip address to a maximum bandwidth of 10 Mbps.

What is a benefit of using application steering in SD-WAN?


A. The traffic always skips the regular policy routes.


B. You steer traffic based on the detected application.


C. You do not need to enable SSL inspection.


D. You do not need to configure firewall policies that accept the SD-WAN traffic.





B.
  You steer traffic based on the detected application.

Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SDWAN?


A. You must set ike-version to 1.


B. You must enable net-device.


C. You must enable auto-discovery-sender.


D. You must disable idle-timeout.





B.
  You must enable net-device.


Page 2 out of 19 Pages
Previous