An administrator wants to configure timeouts for users. Regardless of the userTMs
behavior, the timer should start as soon as the user authenticates and expire after the
configured value.
Which timeout option should be configured on FortiGate?
A network administrator wants to set up redundant IPsec VPN tunnels on FortiGate by using two IPsec VPN tunnels and static routes.
* All traffic must be routed through the primary tunnel when both tunnels are up
* The secondary tunnel must be used only if the primary tunnel goes down
* In addition, FortiGate should be able to detect a dead tunnel to speed up tunnel failover
Which two key configuration changes are needed on FortiGate to meet the design requirements? (Choose two,)
A.
Configure a high distance on the static route for the primary tunnel, and a lower distance
on the static route for the secondary tunnel.
B. Enable Dead Peer Detection.
C. Configure a lower distance on the static route for the primary tunnel, and a higher
distance on the static route for the secondary tunnel.
D. Enable Auto-negotiate and Autokey Keep Alive on the phase 2 configuration of both
tunnels.
B. Enable Dead Peer Detection. C. Configure a lower distance on the static route for the primary tunnel, and a higher
distance on the static route for the secondary tunnel.
When Dead Peer Detection (DPD) is enabled, DPD probes are sent to detect a failed tunnel and bring it down before its IPsec SAs expire. This failure detection mechanism is very useful when you have redundant paths to the same destination, and you want to failover to a backup connection when the primary connection fails to keep the connectivity between the sites up.
There are three DPD modes. On demand is the default mode.
Study Guide – IPsec VPN – Redundant VPNs.
Add one phase 1 configuration for each tunnel. DPD should be enabled on both ends.
Add at least one phase 2 definition for each phase 1.
Add one static route for each path. Use distance or priority to select primary routes over backup routes (routes for the primary VPN must have a lower distance or lower priority than the backup). Alternatively, use dynamic routing. Configure FW policies for each IPsec interface.
Which statement describes a characteristic of automation stitches?
A. They can have one or more triggers.
B. They can be run only on devices in the Security Fabric.
C. They can run multiple actions simultaneously.
D. They can be created on any device in the fabric.
An administrator needs to increase network bandwidth and provide redundancy.
What interface type must the administrator select to bind multiple FortiGate interfaces?
A. VLAN interface
B. Software Switch interface
C. Aggregate interface
D. Redundant interface
C. Aggregate interface
An aggregate interface is a logical interface that combines two or more physical interfaces into one virtual interface1. An aggregate interface can increase network bandwidth and provide redundancy by distributing traffic across multiple physical interfaces using a load balancing algorithm1. An aggregate interface can also support link aggregation control protocol (LACP) to negotiate the link aggregation settings with the connected device1.
