NCP-5.10 Practice Test

A Nutanix cluster is equipped with four nodes. Four VMs on this cluster have been configured with a VM-VM anti-affinity policy and are each being hosted by a different node.
What occurs to the cluster and these VMs during an AHV upgrade?

A. One node hosts two VMs while the node being upgraded is in maintenance mode.

B. One VM out of the four powers down when the node hosting it reboots.

C. The AHV pre-upgrade checks fail until the administrator disables the anti-affinity policy.

D. The AHV pre-upgrade checks fail until the four VMs are powered off.

An administrator needs to boot a VM to a bootable CD. The administrator tries to configure the VM to boot to it, select to add disk, and goes to the images available. The image for the bootable CD is unavailable.
What is the Likely issue?

A. The CD-ROM interface is too slow.

B. The administrator selected a disk attached before it can boot to a CD.

C. The VM needs to have a standard disk attached before it can boot to a CD.

D. The bootable CD image is corrupted during creation.

When VM HA Reservation is enabled, what is the expected behavior for all failed VMs in the event of a host failure?

A. Restart on a best-effort basis if resources are available

B. Perform a live migration to other hosts in the AHV cluster

C. Restart on other hosts in the AHV cluster

D. Perform a live migration on a best-effort basis if resources are available

An administrator needs to report on any alerts generated by a Nutanix cluster that affected the cluster's availability over the past 10 days.
Which method should be used to locate these events?

A. On the Health dashboard, use the Log Collector to export data based on time stamp.

B. Export the cluster event log to a CSV on the Alerts dashboard.

C. On the Alerts dashboard, filter based on Impact Type and the desired Time Range.

D. Configure an Alert Policy to generate an email with the data on the Health dashboard.

An administrator logs in to Prism Element goes to the Network view, and sees the output shown in the exhibit.



Which three steps must the administrator take to increase throughput to the host? (Choose three.)

A. Connect the 10Gb interfaces to the physical switch.

B. Change the bond mode to balance-slb or balance—tcp.

C. Remove any 1Gb interfaces still connected from the default bond.

D. Add a new switch to the network and connect 1Gb interfaces to it.

E. Change the VLAN ID to a higher priority ID.