N10-008 Practice Test

A network engineer performs the following tasks to increaseserver bandwidth:
Connects two network cables from the server to a switch stack
Configure LACP on the switchports
Verifies the correct configurations on the switch interfaces
Which of the following needs to be configured on the server?

A.

Load balancing

B.

Multipathing

C.

NIC teaming

D.

Clustering

A user reports a weak signal when walking 20ft (61 m) away from the WAP in one
direction, but a strong signal when walking 20ft in the opposite direction The technician has
reviewed the configuration and confirmed the channel type is correct There is no jitter or
latency on the connection Which of the following would be the MOST likely cause of the
issue?

A.

Antenna type

B.

Power levels

C.

Frequency

D.

Encryption type

A technician needs to configure a Linux computer for network monitoring. The technician
has the following information:
Linux computer details:

After connecting the Linux computer to the mirror port on the switch, which of the following
commands should the technician run on the Linux computer?

A.

ifconfig ecth0 promisc

B.

ifconfig eth1 up

C.

ifconfig eth0 10.1.2.3

D.

ifconfig eth1 hw ether A1:B2:C3:D4:E5:F6

A network technician has multimode fiber optic cable available in an existing IDF. Which of
the following Ethernet standards should the technician use to connect the network switch to
the existing fiber?

A.

10GBaseT

B.

1000BaseT

C.

1000BaseSX

D.

1000BaseLX

Atechnician is installing a high-density wireless network and wants to use an available
frequency that supports the maximum number of channels to reduce interference. Which of
the following standard 802.11 frequency ranges should the technician look for while
reviewing WAP specifications?

A.

2.4GHz

B.

5GHz

C.

6GHz

D.

900MHz