Topic 2: Exam Pool B
When the Access type port sends a message, it will ().
A.
Strip the VLAN information of the high packet, and then send it out
B.
Type the PVID. information of this port, and then send it out
C.
Send tagged messages
D.
Add the VLAN information of the message, and then send it out
Strip the VLAN information of the high packet, and then send it out
VRP operating platform, which of the following commands can only view static routes? ()
A.
display ip routing-table protocol static
B.
display ip routing-table
C.
display ip routing-table verbose
D.
display ip routing-table statistics
display ip routing-table protocol static
The configuration information of a certain interface of the router is shown in the figure.
Which VILAN data packet can this port receive? ()
interface Gigabit Ethernet 0/0/2.30 dotlq terainatlon viD.100 ip address 10.0.21.1
255.255.255.0 arp broadcast enable
A.
100
B.
30
C.
20
30
The administrator wants to allocate a Hundred P address on the G0/0/0 interface of the
router. Which of the following addresses is correct? ()
A.
192.168.10.112/30
B.
237.6.1.2/24
C.
127.3.1.4/28
D.
145.4.2.55/26
145.4.2.55/26
Two switches use manual link aggregation at the same time. The following statement is
wrong. () (Single-choice question)
A.
Only switch off G0/0/2 port on switch B. The Eth-Trunk status is still UP
B.
Turn off the G0/0/1 and G0/0/2 ports on switch B, and the Efh-Trunk status is still UP
C.
Only switch off G0/0/1 port on switch B. The Eth-Trunk status is still UP
D.
Turn off the G0/0/1 and G0/0/2 ports on switch B. The Eth-Trunk status is down
Turn off the G0/0/1 and G0/0/2 ports on switch B, and the Efh-Trunk status is still UP
Page 6 out of 143 Pages |
Previous |