350-601 Practice Test

Which action must be performed before renumbering a Cisco UCS chassis?

A.

Move the chassis to new ports on fibric interconnect.

B.

Re-acknowledge the chassis.

C.

Decommission the chassis.

D.

Run the shut and no shut command on the connected ports.

An engineer is running an ACI fabric, has VMM integration with VMware vCenter, and wants to enable microsegmentation based on vCenter VM attributes. Which statement about microsegmentation is true?

A.

ACI does not support microsegmentation based on vCenter VM attributes. You should use network attributes for mircosegmentation.

B.

An ACI microsegmented EPG automatically creates a port group with a private VLAN configured on a VMware vCenter distributed virtual switch.

C.

When enabled, microsegmentation performs distributed switching and routing on the ESXi hosts.

D.

Microsegmentation is supported only using AVE or AVS.

Refer to the exhibit.

An engineer configures FCIP on a Cisco MDS 9000 Series switch. What is the result of implementing the configuration?

A.

The switch attempts to make two TCP connections

B.

Compression is performed by using hardware

C.

Mode2 is enabled by default.

D.

Compression is performed by using software

An engineer is implementing OTV on a transport that supports multicast. The solution needs to meet the
following requirements:
• Establish adjacency to the remote peer by using multicast.
• Enable OTV advertisements for VLAN 100 to the other site.
Which two commands should be configured to meet these requirements? (Choose two.)

A.

otv site-vlan 100

B.

otv data-group 232.2.2.0/28

C.

otv use-adjacency-server 172.27.255.94

D.

otv extend-vlan 100

E.

otv control-group 232.1.1.1

Which mroute state is created when Bidirectional PIM is deployed at a site?

A.

MVPN Type-6

B.

*,G

C.

MVPN Type-7

D.

S,G