- Email support@dumps4free.com
Topic 2: Exam Pool B
Which new enhancement was implemented in Wi-Fi 6?
A.
Wi-Fi Protected Access 3
B.
4096 Quadrature Amplitude Modulation Mode
C.
Channel bonding
D.
Uplink and Downlink Orthogonal Frequency Division Multiple Access
Uplink and Downlink Orthogonal Frequency Division Multiple Access
Which OSPF networks types are compatible and allow communication through the two peering devices?
A.
broadcast to nonbroadcast
B.
point-to-multipoint to nonbroadcast
C.
broadcast to point-to-point
D.
point-to-multipoint to broadcast
broadcast to nonbroadcast
Explanation: The following different OSPF types are compatible with each other:
+ Broadcast and Non-Broadcast (adjust hello/dead timers)
+ Point-to-Point and Point-to-Multipoint (adjust hello/dead timers)
Broadcast and Non-Broadcast networks elect DR/BDR so they are compatible.
Pointtopoint/multipoint do not elect DR/BDR so they are compatible.
Refer to the exhibit.
An engineer must permit traffic from these networks and block all other traffic An informational log message should be triggered when traffic enters from these prefixes. Which access list must be used?
A.
access-list acl_subnets permit ip 10.0.32.0 0 0.0.255 log
B.
access-list acl_subnets permit ip 10.0.32.0 0.0.7.255 log
C.
access-list acl_subnets permit ip 10.0.32.0 0.0.7.255 access-list acl_subnets deny ip any log
D.
access-list acl_subnets permit ip 10.0.32.0 255.255.248.0 log
access-list acl_subnets permit ip 10.0.32.0 0.0.7.255 log
An engineer is configuring local web authentication on a WLAN. The engineer chooses the Authentication radio button under the Layer 3 Security options for Web Policy. Which device presents the web authentication for the WLAN?
A.
ISE server
B.
local WLC
C.
RADIUS server
D.
anchor WLC
local WLC
Explanation:
“The next step is to configure the WLC for the Internal web authentication. Internal web authentication is the defaultweb authentication type on WLCs.” In step 4 of the link above, we will configure Security as described in this question. Therefore we can deduce thisconfiguration is for Internal web authentication. This paragraph was taken from the link:
https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wlan-security/69340-webauth-config.html#c5 :
Refer to the exhibit.
A.
Option A
B.
Option B
C.
Option C
D.
Option D
Option B
| Page 64 out of 168 Pages |
| Previous |