350-401 Practice Test

Refer to the exhibit.

A network architect has partially configured static NAT. which commands should be asked to complete the configuration?

A.

R1(config)#interface GigabitEthernet0/0 R1(config)#ip pat outside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip pat inside

B.

R1(config)#interface GigabitEthernet0/0 R1(config)#ip nat outside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip nat inside

C.

R1(config)#interface GigabitEthernet0/0 R1(config)#ip nat inside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip nat outside

D.

R1(config)#interface GigabitEthernet0/0 R1(config)#ip pat inside
R1(config)#interface GigabitEthernet0/1 R1(config)#ip pat outside

An engineer creates the configuration below. Drag and drop the authentication methods from the left into the order of priority on the right. Not all options are used.

Refer to the exhibit.

An engineer attempts to bundle interface Gi0/0 into the port channel, but it does not function as expected. Which action resolves the issue?

A.

Configure channel-group 1 mode active on interface Gi0/0.

B.

Configure no shutdown on interface Gi0/0

C.

Enable fast LACP PDUs on interface Gi0/0.

D.

Set LACP max-bundle to 2 on interface Port-channeM

Refer the exhibit.

\Which router is the designated router on the segment 192.168.0.0/24?

A.

This segment has no designated router because it is a nonbroadcast network type.

B.

This segment has no designated router because it is a p2p network type.

C.

Router Chicago because it has a lower router ID

D.

Router NewYork because it has a higher router ID

Refer to the exhibit.

After the code is run on a Cisco IOS-XE router, the response code is 204. What is the result of the script?

A.

The configuration fails because another interface is already configured with IP address 10.10.10.1/24.

B.

The configuration fails because interface GigabitEthernet2 is missing on the target device.

C.

The configuration is successfully sent to the device in cleartext.

D.

Interface GigabitEthernet2 is configured with IP address 10.10.10.1/24