301a Practice Test

An LTM device configured with a management IP address and route and a series of self-IPs and TMM routes. Both management and TMM have a routing entry for 101 10/24 Application traffic is being load balanced and sent to pool member 10.1.1.123 with SNAT Automap and configured. Which route will the LTM device use?

A. TMM route regardless of the management port status

B. both routes, which will duplicate traffic on both management and TMM interface

C. equal cost multipath load balancing via both routes

D. management route when TMM interface is down or TMM is offline

An LTM device load balances a pool of routers. The LTM device needs to verify path availability to an HTTP server with the IP address 192 168.10 10. located beyond the routers. Which monitor type and parameters arc required?

A. HTTP monitor alias address 192 168.10 10. and set the alias to port 80

B. TCP monitor, alias address 192.168.10.10. and set the alias to port 80

C. TCP monitor change transparent option to Yes. set alias address 192.168.10.10. and set the alias to port 80

D. TCP monitor, change transparent option to Yes, and sot the alias to port 80

AN LTM Specialist is setting up a new HTTPS virtual server to decrypt client traffic. SNAT the traffic and send the encrypted traffic to the poor member, the client's IP address must be included in the traffic sent to the pool member. What is a complete set of profiles that must be configured for the virtual server to meet these requirements?

A. TCP, Client SSL, Server SSL

B. TCP , Server SSL, HTTP

C. TCP, Client SSL, HTTP

D. TCP, Client SSL, Server SSL, HTTP

An LTM Specialist needs to apply SNAT using currently used SNAT pool to a new virtual server. What needs to be completed before applying that configuration change?

A. Review connection for the selected SNAT pool and enlarge it if appropriate

B. Make sure that the BIG-IP device is NOT operating under heavy load during peak times

C. Verify that the IP address of the SNAT pool are in the same subnet as the pool members

D. Verify that the IP address of the SNAT pool are in the same VLAN as the pool members.

An unwanted IP address tries to connect to the configuration utility via Self IP An LTM Specialist needs to block the attempts based on the IP address. How should the ITM Specialist block the attempts without affecting other users?

A. SSH IP allow list

B. Port lockdown

C. Device trust

D. Packet filter