Drag and drop the Cisco ACI filter entry options from the left onto the correct categories on the right indicating what are required or optional parameters.
An engineer has set the VMM resolution immediacy to pre-provision in a Cisco ACI
environment. No Cisco Discovery Protocol neighborship has been formed between the
hypervisors and the ACI fabric leaf nodes. How does this affect the download policies to
the leaf switches?
A.
No policies are downloaded because LLDP is the only supported discovery protocol.
B.
Policies are downloaded when the hypervisor host is connected to the VMM VDS.
C.
Policies are downloaded to the ACI leaf switch regardless of Cisco Discovery Protocol neighborship.
D.
No policies are downloaded because there is no discovery protocol neighborship
Policies are downloaded to the ACI leaf switch regardless of Cisco Discovery Protocol neighborship.
An engineer needs to deploy a leaf access port policy group in ACI Fabric to support the
following requirements:
• Control the amount of application data flowing into the system
• Allow the newly connected device to auto-negotiate link speed with the leaf switch
Which two ACI policies must be configured to achieve these requirements? (Choose two.)
A.
L2 interface policy
B.
link level policy
C.
slow drain policy
D.
ingress control plane policing policy
E.
ingress data plane policing policy
link level policy
ingress data plane policing policy
Slow Drain handles FCoE packets that are causing traffic congestion on ACI fabric. So, it is
wrong.
Ingress control plane is wrong, because the request is for “application data flowing”.
L2 interface policy is concerned about QinQ and VLAN scope.
Which method does the Cisco ACI fabric use to load-balance multidestination traffic?
A.
PIM routing
B.
spanning trees
C.
shortest-path trees
D.
forwarding tag trees
forwarding tag trees
Explanation: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-
x/aci-fundamentals/b_ACI-Fundamentals/b_ACI-Fundamentals_chapter_010010.html
What must be configured to redistribute externally learned OSPF routes within the ACI fabric?
A.
Route Control Profile
B.
BGP Route Reflector
C.
BGP Inter-leak Route Map
D.
PIM Sparse Mode
Route Control Profile
Reference: https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-
x/ACI_Best_Practices/
b_ACI_Best_Practices/b_ACI_Best_Practices_chapter_010010.html
Page 3 out of 16 Pages |
Previous |