300-615 Practice Test

Refer to the exhibits.

An engineer troubleshoots switch N5K1, which fails to receive traffic from the file server
Which set of actions resolves this problem?

A.

Bind native VLAN 10 with Ethemet1/10 and allow VSAN 101 in trunk configuration.

B.

Assign native VLAN 10 with vfc111 and allow VLAN 1101 in trunk configuration.

C.

Bind native VLAN 10 with Ethemet10/1/1 and allow VLAN 10 in trunk configuration

D.

Assign native VLAN 10 with fc2.'l - 2 and allow VLAN 10 in trunk configuration.

A customer configures HSRP between two data centers that are interconnected with OTV.
The configuration succeeds, but traffic between two ESXi virtual hosts on the same site is
routed suboptimally through the OTV overlay. Which two actions optimize the traffic?
(Choose two.)

A.

Disable first-hop redundancy.

B.

Filter HSRP traffic by using a Layer 3 VACL on the OTV edge devices.

C.

Filter HSRP by using a Layer 2 MAC-list on the ESXi vSwitch.

D.

Filter HSRP traffic by using a Layer 3 VACL on the ESXi vSwitch

E.

Filter HSRP by using a Layer 2 MAC-list on the OTV edge devic

An engineer must configure Linux hosts that are deployed on Cisco UCS B-Series Servers
to boot from SAN. The SAN boot policy is configured in Cisco UCS Manager, and the boot
order is verified to be set as expected However, the Linux hosts fail to boot. Which action
resolves the issue?

A.

Remove all of the local storage that is installed

B.

Delete and reconfigure the pWWN of the SAN boot target

C.

Remove all of the ISO images that are mounted as a virtual CD-ROM

D.

Delete and reconfigure the boot LUN

Refer to the exhibit.

A switch is being downgraded to an earlier release because of a problem with the current
release. After the switch is downgraded, it can no longer forward traffic. Which action
resolves the issue?

A.

Enable ISSD after the downgrade is complete.

B.

Roll back to the original image.

C.

Reload the switch.

D.

Shut and no shut the interfaces to the FEX.

Refer to the exhibit

The vPC between switch1 and switch2 does not work. Which two actions resolve the
problem? (Choose two.)

A.

Configure the IP address on the interface.

B.

Activate VLANs on the vPC.

C.

Configure one of the switches as primary for the vPC.

D.

Correct the configuration of the vPC peer link and the vPC peer keepalive.

E.

Match the vPC domain ID between the two devices.