300-615 Practice Test

During a boot process of a Cisco UCS C-Series Rack Server, an engineer receives a "No
Signal" message from the vKVM and physical connection. Which set of steps resolves the
issue?

A.

1- Disconnect the power cord
2- Confirm that all cards are property seated
3- Connect the power cord and power on the server

B.

1- Power off the server and disconnect the power cord
2- Confirm that all cards are property seated
3- Connect the power cord and power on the server

C.

1- Power off the server and disconnect the power cord
2- Confirm that all cards are available
3- Connect the power cord and power on the server

D.

1- Disconnect the power cord
2- Confirm that all cards are properly seated
3- Connect the power cord

A server administrator attempts to change the Cisco IMC KVM certificate to one signed by
a private CA, but the certificate is not being accepted. What can cause this process to fail?

A.

using a certificate with a password-protected private key

B.

RSA encryption being used in the generation of the certificate.

C.

AES encryption being used in the generation of the certificate.

D.

public IP addres of the Cisco IMC not being included in the SAN

An engineer enables the packet postcards feature on a Cisco Nexus 9000 Series Switch
but receives the error message "Error: Cannot configure postcard when inband-telemetry is
configured."
Which action resolves the issue?

A.

Disable the telemetry feature

B.

Disable the software-telemetry feature

C.

Disable the hardware-telemetry feature

D.

Disable the inband-telemetry feature

Refer to the exhibit.

A new Cisco Nexus 5548 Switch connects to a network. SAN switching is configured on the
switch. The switch fc2/10 NP uplink is shown in the exhibit. Which action ensures that
fc2/10 is in an up state?

A.

Replace the SFP port module in fc2/10.

B.

Configure the admin port type E on the upstream switch that connects the port.

C.

Enable NPIV on the upstream switch that connects the port.

D.

Configure the BB_credit buffers on the upstream switch that connects the port.

An engineer is troubleshooting a packet flow from an access leaf to spine. Which EVPN
routes are expected on this connection?

A.

EVPN Type 1-5

B.

EVPN Type 0,9,15

C.

EVPN Type 9-15

D.

EVPN Type 0,16