300-410 Practice Test

Refer to the exhibit.

A user cannot SSH to the router. What action must be taken to resolve this issue?

A.

Configure transport input ssh

B.

Configure transport output ssh

C.

Configure ip ssh version 2

D.

Configure ip ssh source-interface loopback0

Refer to the exhibit. A network administrator configured NTP on a Cisco router to get synchronized time for system and logs from a unified time source The configuration did not work as desired Which service must be enabled to resolve the issue?

A.

Enter the service timestamps log datetime localtime global command.

B.

Enter the service timestamps log datetime synchronize global command.

C.

Enter the service timestamps log datetime console global command.

D.

Enter the service timestamps log datetime clock-period global command

Refer to the exhibit.

An IT staff member comes into the office during normal office hours and cannot access devices through SSH Which action should be taken to resolve this issue?

A.

Modify the access list to use the correct IP address.

B.

Configure the correct time range.

C.

Modify the access list to correct the subnet mask

D.

Configure the access list in the outbound direction.

Refer to the exhibit. R2 has two paths to reach 192.168.13.0/24. but traffic is sent only through R3. Which action allows traffic to use both paths?

A.

Configure the bandwidth 2000 command under interface FastEthernet0/0 on R2.

B.

Configure the variance 4 command under the EIGRP process on R2.

C.

Configure the delay 1 command under interface FastEthernet0/0 on R2.

D.

Configure the variance 2 command under the EIGRP process on R2

Refer to the exhibit.

A network administrator reviews the branch router console log to troubleshoot the OSPF adjacency issue with the DR router. Which action resolves this issue?

A.

Advertise the branch WAN interface matching subnet for the DR site.

B.

Configure matching hello and dead intervals between sites.

C.

Configure the WAN interface for DR site in the related OSPF area.

D.

Stabilize the DR site flapping link to establish OSPF adjacency.