300-410 Practice Test

Refer to the exhibit.

An engineer is troubleshooting BGP on a device but discovers that the clock on the device does not correspond to the time stamp of the log entries. Which action ensures consistency between the two times?

 

A.

Configure the service timestamps log uptime command in global configuration mode.

B.

Configure the logging clock synchronize command in global configuration mode.

C.

Configure the service timestamps log datetime localtime command in global configuration mode

D.

Make sure that the clock on the device is synchronized with an NTP server.

While troubleshooting connectivity issues to a router, these details are noticed:

Standard pings to all router interfaces, including loopbacks, are successful.
Data traffic is unaffected.
SNMP connectivity is intermittent.
SSH is either slow or disconnects frequently.
Which command must be configured first to troubleshoot this issue?

A.

show policy-map control-plane

B.

show policy-map

C.

show interface | inc drop

D.

show ip route

Refer to the exhibit.

The network administrator configured VRF lite for customer A. The technician at the remote site misconfigured VRF on the router. Which configuration will resolve connectivity for both sites of customer_a?

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Refer to the following output:

Router#show ip nhrp detail

10.1.1.2/8 via 10.2.1.2, Tunnel1 created 00:00:12, expire 01:59:47
TypE. dynamic, Flags: authoritative unique nat registered used
NBMA address: 10.12.1.2
What does the authoritative flag mean in regards to the NHRP information?

A.

It was obtained directly from the next-hop server.

B.

Data packets are process switches for this mapping entry.

C.

NHRP mapping is for networks that are local to this router.

D.

The mapping entry was created in response to an NHRP registration request.

E.

The NHRP mapping entry cannot be overwritten.

Refer to the exhibit.

AAA server 10.1.1.1 is configured with the default authentication and accounting settings, but the switch cannot communicate with the server Which action resolves this issue?

 

A.

Match the authentication port

B.

Match the accounting port

C.

Correct the timeout value

D.

Correct the shared secret