156-315.81 Practice Test

Due to high CPU workload on the Security Gateway, the security administrator decided to purchase a new multicore CPU to replace the existing single core CPU. After installation, is the administrator required to perform any additional tasks?

A. After upgrading the hardware, increase the number of kernel instances using cpconfig

B. Hyperthreading must be enabled in the bios to use CoreXL

C. Run cprestart from dish

D. Administrator does not need to perform any task. Check Point will make use of the newly installed CPU and Cores.

Matt wants to upgrade his old Security Management server to R81.x using the Advanced Upgrade with Database Migration. What is one of the requirements for a successful upgrade?

A. Size of the /var/log folder of the source machine must be at least 25% of the size of the /var/log directory on the target machine

B. Size of the /var/log folder of the target machine must be at least 25% of the size of the /var/log directory on the source machine

C. Size of the $FWDIR/log folder of the target machine must be at least 30% of the size of the $FWDIR/log directory on the source machine

D. Size of the /var/log folder of the target machine must be at least 25GB or more

After some changes in the firewall policy you run into some issues. You want to test if the policy from two weeks ago have the same issue. You don't want to lose the changes from the last weeks. What is the best way to do it?

A. Use the Gaia WebUI to take a backup of the Gateway. In SmartConsole under Security Policies go to the Installation History view of the Gateway, select the policy version from two weeks ago and press the 'Install specific version' button

B. Use the Gaia WebUI to take a snapshot of management. In the In SmartConsole under Manage & Settlings go to Sessions -> Revisions and select the revision from two weeks ago. Run the action 'Revert to this revision...' Restore the management snapshot.

C. In SmartConsole under Manage & Settings go to Sessions -> Revisions and select the revision from two weeks ago. Run the action 'Revert to this revision...'.

D. In SmartConsole under Security Policies go to the Installation History view of the Gateway, select the policy version from two weeks ago and press the 'Install specific version' button

What is the command to check the status of the SmartEvent Correlation Unit?

A. fw ctl get int cpsead_stat

B. cpstat cpsead

C. fw ctl stat cpsemd

D. cp_conf get_stat cpsemd

You have used the "set inactivity-timeout 120" command to prevent the session to be disconnected after 10 minutes of inactivity. However, the Web session is being disconnected after 10 minutes. Why?

A. The idle timeout for the web session is specified with the "set web session-timeout" command.

B. The number specified is the amount of the idle timeout in seconds rather than in minutes. So you have to use the command "set inactivity-timeout 600" instead.

C. Probably, you have forgotten to make sure that nobody is accessing the management server via the SmartConsole which locks the management database.

D. The number of minutes is correct. Probably, you have forgotten to save this setting with the "save config" command.